Material: hardened and tempered steel (to guarantee long lasting)
Description
This system is suitable for the drilling of the bumpers, in order to apply any of parking’s sensor model. The punches can be used with a manual ratchet or more quickly with an electric or pneumatic screwdriver (bushing CH= 13 mm).
Making the cut from the outside towards the inside you can also make the hole on the bumper just painted and also the drilling does not present the slightest deburring, thus being able to mount also sensors without the support frame.
N.B.: For the use of punches, you must do a hole of 8,5 mm on the bumper.
The kit of bumper is actually available in the version of 5 pieces (ref. ST0220000) having 17-18-19-20-21 mm. diameters and version of 6 pieces (ref. ST0220006) with the addition of 22 mm diameter. And is also available a single punch of 27 mm diameter (ref. ST0220027).
We also have made some improvements as:
1 - Marking the reference diameters on each punch.
2 - Tempered male punch reduced in order to facilitate the removal from the drilled bumper.
Enter the e-mail address you use for the customer area and you will receive an e-mail containing your Password.
This site uses technical cookies and analytics, by third parties as well, that allow us to provide a better service. To get more information or to deny the consent to all or some cookies please click on the "Further information" button. If you continue surfing or scrolling this page, you accept our cookie policy.